latest steam boiler ever built

Details


  • Production capacity: 7-70 MW
  • Work pressure: 1.0-1.6 Mpa
  • Applicable fuel: Nature gas, coke oven gas, blast furnace gas, carbon black off-gas, biogas, methanol, etc.
  • Applicable industry: heat suppling, hospital, colleges and universities.


Product introduction

  SZS Series Boiler is double drums, longitudinal arranged, "D" type chamber structure. Furnace is on right side and convection tube bundle is on the left. The body is fixed on the basement by middle and both end flexible supports and make the boiler to expand horizontally to sideways. Around furnace is membrane water cooling tube wall. Furnace and tube bundle is totally separated by the membrane water tube cooling wall at the left side of the furnace. The back part of bundle is sparse shift structure, front part is aligned structure. Smoke from furnace outlet enters re-burning chamber, bundle area, and then from left front part enters spiral fin coil economizer and condenser, finally discharged to atmosphere through chimney.





Safety

  Boiler body high temperature area adopt forced circulation to make sure each part heating area can be cooled down and avoid vaporization;

  Boiler has explosion door and flame detector for safe and reliable operation.

  comb plates are used as the sealing between both sides of boiler and tube bundle all use to avoid leakage of condensate and gas which is caused by refractory concrete sealing.

  air tightness test is done before leaving the factory to ensure no leakage of gas.

environmental protection

  Bigger combustion chamber and Low emission combustion engine to reduce the NOX to 30mg/Nm3

  Smoke duct and smoke outlet has internal insulation to reduce operating noise.

  Combustion chamber use full membrane water cooling wall structure, pressurized firing without smoke mixture.

energy conservation

  Good quality alumina silicate fiber and fire clay insulation is used, boiler body temperature is controlled below 45℃, to reduce heat lost.

  Combustion chamber use narrow distance tube membrane water cooling wall which has good air tightness, and reduce heat lost and increase boiler thermal efficiency.

  Inside of Inspection holes use high-alumina refractory and man hole cover sealing devices, it solved the high temperature of this part by using refractory brick

Convenience

  Thera are manholes on front and back side of both bundle and inspection doors on back side of boiler, which are easy to open for inspection and cleaning inner part.

longer lifespan

  Membrane structure of Front and back wall is used for boiler body, which highly increased their lifespan to over 20 years.

  The key part such as material cutting, rolling, drilling are proceeded by advanced CNC machining process to reduce the assemble stress and extend boiler working lifetime.

  flutter prevention fastener is used for high temperature part convection tube, which avoid bundle tube cracking problem.

  Longitudinal and girth joint adopt advanced automatic submerged-arc welding for good welding quality. All longitudinal and girth joint will have 100% radiographic inspection.

 
Items
Model
SZS7-1.0/115/70-Q SZS10.5-1.0/115/70-Q SZS14-1.25/115/70-Q SZS17.5-1.25/115/70-Q SZS21-1.25/130/70-Q SZS29-1.25/130/70-Q SZS46-1.6/130/70-Q SZS58-1.6/130/70-Q SZS70-1.6/130/70-Q SZS116-1.6/130/70-Q
Rated thermal power(MW) 7.0 10.5 14.0 17.5 21.0 29 46 58 70 116
Rated working pressure(MPa) 1.0 1.0 1.25 1.25 1.25 1.25 1.6 1.6 1.6 1.6
Rated output water temperature(℃) 115 115 115 115 130 130 130 130 130 130
Rated Feeding water temperature(℃) 70 70 70 70 70 70 70 70 70 70
Heating area(㎡) Main body(㎡) 168.0 220.0 245.30 284.40 394.75 428.1 1065.9 1225.7 1408.4 6164.8
Condenser (㎡) 164.0 306.0 527.0 645.1 738.3 990.8 985.3 1292.5 1642.1 1830
Available fuel Natural gas, biogas, coke oven gas, light oil, methanol, biodiesel etc
Gas consumption(Nm³/h) 720 1080 1440 1800 2160 2982 4680 5760 7200 11880
Thermal efficiency(%) >98 >98 >98 >98 >98 >98 >98 >98 >98 >98
MAX.transportation weight(t) 42.0 48.0 52.5 57.5 65.0 72.5 散件12.6 散件13.8 散件16 散件20
MAX. transportation dimension LxWxH(m) 7.87x3.40x3.34 8.85x3.85x3.93 8.51x3.85x3.75 9.31x3.77x3.75 10.10x4.13x4.15 10.90x4.13x4.15 11.00xΦ1.45 11.10xΦ1.46 12.00xΦ1.66 12.50xΦ1.66

CONTACT FORM



Engine 9 is a three truck Shay type locomotive built by Lima Locomotive Works, To compensate for the weight of the engines the boiler sits off center to the left. three largest narrow gauge Shays ever built, producing 36,150 lbs. tractive effort. The West Side lasted until the early 1960s, and was the last steam-powered

The Boilers | RMS Titanic Remembered

The Titanic was built as a &8220;triple-screw steamer,&8221; which meant that she had three to turn, steam was needed in greater quantities than any ship had ever before

This is an instructable for my small sized steam boiler. you can share what you make with the world, and tap into an ever-growing community of creative experts. The unit was built entirely in my apartment with a hand drill and a rotary tool.

May 31, 2012 A steam train built in 1937 is getting a makeover that will turn it into a &8220;higher-speed&8221; . A steam boiler has to be torn down and rebuilt about every five years. needs would be the most carbon neutral energy policy ever conceived See the attached links for recent shots of operating steam locomotives:.

Steam and hot water; 100 to 1,200 HP; Natural gas, 2 light oil or combination resulting in the most efficient and lowest-emission firetube system ever built.

Nov 10, 2010 Later, as an MIT student in 1911, Abner built a steamer with a condenser that turned Superheated steam from a 1200-psi front-mounted boiler drives a and it pulls away faster than you&39;d ever think possible in an 85-year-old car. It proves what I&39;ve always believed: The last days of an old technology

Who Invented the Steam Engine? &8211; LiveScience

Mar 19, 2014 The steam engine may seem like a relic of the past. Early in the first century A.D., a Greek inventor named Hero of Alexandria designed the world&39;s first aeolipile, or primitive steam turbine. Using two steam boilers, Savery devised a nearly continuous . Latest On Who Invented the Steam Engine?

In 1814, the first successful steam engine locomotive was built by the British tube boilers that were commonly used in steam locomotives here typically built

Feb 18, 2013 For the last 90 years, steam cars have remained on the verge of and some kind of flash boiler, and it should be possible to build a steam car with Moving forward, it&39;s unlikely that steam cars will ever unseat the internal

The last revenue freight pulled by a Big Boy was in July of 1959. Anatole Mallet designed his steam locomotive that 1) was articulated, and 2) Books and magazines will often state that the Big Boy was the largest steam locomotive ever built. . The boiler jacketing has been removed to prevent moisture entrapment.

Oct 24, 2006 The boilers had to be lit by hand, and they required about twenty minutes Though it did not run well, the Doble brothers went on to build a second supply to last about 1,500 miles in contrast to a typical steamer&39;s 100 miles.

York &8211; unmissable engines &8211; Our collection &8211; National Railway Museum

The main features were: a multi-tubular boiler, to improve the heat transfer from the These locos were the largest single-unit locomotives ever built in the UK. Evening Star was the last steam locomotive to be built for British Railways.

Nov 3, 2011 A home steam system consists of a boiler with a furnace to turn water to It should be fairly obvious that a furnace built to burn logs and twigs is not devices went into orbit during the last century and the early days of this one. If you have ever seen an old 10 to 16 horsepower steam tractor at a "trac

Engine 9 is a three truck Shay type locomotive built by Lima Locomotive Works, To compensate for the weight of the engines the boiler sits off center to the left. three largest narrow gauge Shays ever built, producing 36,150 lbs. tractive effort. The West Side lasted until the early 1960s, and was the last steam-powered

The Titanic was built as a &8220;triple-screw steamer,&8221; which meant that she had three to turn, steam was needed in greater quantities than any ship had ever before

This is an instructable for my small sized steam boiler. you can share what you make with the world, and tap into an ever-growing community of creative experts. The unit was built entirely in my apartment with a hand drill and a rotary tool.